Tag Archives: Quilt Sleeve

My Simple, No Hand Sewing, Hanging Sleeve.

Traditional quilt shows use a rod and pole display system.

                                  

The sleeve for this hanging system is very important to making a pleasing display. A sleeve is a fabric tube sewn on the completed quilt by hand. A sleeve is 4 inches wide placed an inch from the top and sides. The sleeve has enough “give” so the quilt hangs flat.

Art Quilter’s”  use a sleeve with a wood or plexiglass slat. 

The slat has holes at the end that can be wired and hung on any gallery wall. Unlike art in a frame and under glass, art quilts are economical to ship and easily stored. This is an incentive for galleries and museums to display our work. (Check out this SAQA resource about hanging quilts in a traditional gallery) 


I didn’t really understand the importance of the sleeve when I first began making art quilts. For a time I backed my quilts with canvas or other materials. My sleeve was sewn flat to the backing. This works well if you are using small nails at the end of the sleeve, but is a poor choice for any rod system.

After some experimentation, I found a simple way to make a sleeve that does not require hand sewing and can be easily removed.

I use Oly*fun.
It’s a poly fabric used for crafting. Although it comes in many colors, I use black exclusively. You can buy it online or at Walmart or Joannes in 10 yard bolts. It is 60″ wide.
The fabric is super light and cheap.

                                                       

                             (Be forewarned: you cannot iron this stuff!)


Here’s my process

  1. Set out a rotary cutter, white marking pencil and ruler. Measure the width of the quilt. Cut a 4.5  inch strip.  Cut a 6 inch strip. Roll up extra and keep these on hand for the next project. 
  2. Lay the 6” piece over the top edge of your quilt . (I don’t use a ruler!) Leave an inch on the outer edge. Mark with white pencil and trim to size. Make a 1” line with your with  pencil on all for sides of your 6” piece. It will look like a frame. 
     

 

3.Place the 4.5 inch piece so it lines up with the top 1 inch line – not top of the 6″ strip.  Mark and trim this piece so it fits between the side border lines. Pin this piece so it lines up with the top border and sew a quarter inch seam.Line up the bottom of the 4” with the bottom border line. This  will not lay flat! It creates a tunnel.

4. Next I spray adhesive to the back of my quilt and sew along the outside edges (side, top, side). 

                      

You’re done!

Until the next time…..
Margaret

You can see my work……. 
Turmoil
International Quilt Festival – Chicago, Illinois: April 2017 

Under The Western Sun
Rocky Mountain Quilt Museum, Golden CO
April 27 – July 25 2017

H2Oh!
National Quilt Museum, Paducah Kentucky
June – September 2017

Sacred Threads
Herndon VA
 July 7 – 23 2017 and Traveling through out the country!

Pathfinders
Southern Utah Museum of Art
Cedar City Utah 
June 30 – August 26 2017

The View
St. George Museum of Art
St. George Utah
April 28 – August 16 2017

Untethered Thread
Poway Center for the Arts
Poway, CA
June 1 – June 24, 2017

35th Annual New Legacies
Lincoln Center 
Ft. Collins, CO 
July 5 – August 26

Interpretations: Conversations
Visions Art Museum
San Diego, CA
October 21 2017 – January 7 2018